APC SMT 2200 - User Manual

Installation Guide SMT 2200/3000 VA
Optional Replacement PDU
Safety
Adhere to all national and local electrical codes. A certified electrician must perform all
electrical connections.
1. Disconnect equipment connected to the UPS.
2. Press the OFF button located on the front of the UPS.
3. Disconnect the batteries in the UPS.
4. Disconnect the UPS from utility power.
Installation
Note: The illustrations in this manual may differ slightly in appearance from the actual
hardware.
Remove the five screws that secure the factory
installed PDU panel to the UPS. Save the screws.
Disconnect the PDU output cables as shown in the
diagrams.
Do not disconnect the AC input connector.
su06695a
A
C Input Connector

APC SMT 2200 Specifications

General

Model	SMT2200
Nominal Output Voltage	230V
Nominal Input Voltage	230V
Input Voltage Range (Main Operation)	160 - 286 V
Output Power Capacity	2200 VA / 1980 W
Output Connections	(8) IEC 320 C13
Battery Type	Sealed Lead Acid (SLA)
Maximum Height	290 mm
Maximum Depth	544 mm
Dimensions	430 mm
Operating Temperature	0 - 40 °C
Operating Humidity	0 - 95% relative humidity, non-condensing
Transfer Time	4-6 ms
Control Panel	LCD display

Summary

Safety

Safety Precautions and Procedures

Adherence to electrical codes and essential steps for safe UPS disconnection before installation.

Installation

PDU Panel Removal and Disconnection

Steps for removing the factory PDU panel and disconnecting its output cables.

Connecting and Securing Replacement PDU

Instructions for connecting the new PDU panel and securing it to the UPS unit.

APC Worldwide Customer Support

Customer Support Channels

Information on accessing APC customer support via website, e-support, and telephone.