Need help?Do you have a question about the APC Back UPS 1000 and is the answer not in the manual?
General| Input Frequency | 50/60Hz |
|---|---|
| Typical Recharge Time | 8 hours |
| Battery Type | Sealed Lead-Acid (SLA) |
| Audible Alarm | Yes |
| Output Power Capacity | 600W |
Remove the screw and slide off the cover to access the battery.
Disconnect battery wires, replace the battery, and reconnect wires.
Close the cover and reinstall the screw to complete the process.
Press release tabs and slide the cover off to access the battery.
Disconnect wires, replace with new battery, and reconnect.
Close the cover to complete the battery replacement.
Press release tabs and slide off the cover to access the battery.
Disconnect wires, replace with new battery, and reconnect.
Close the cover to complete the battery replacement.
Unhook, swing the front panel, pull out the battery tray, and open it.
Connect the battery wires, noting Red (+) and Black (-).
Unhook, swing the front panel, pull out the battery tray, and open it.
Connect the battery wires, noting Red (+) and Black (-).
Remove the battery pack, pull the battery, and open the pack.
Connect the battery and use the foam spacer as needed.
Tilt the unit, unhook, open the compartment, and pull the battery.
Connect the battery and use the foam spacer as required.
Release tabs and slide off the battery door to access the battery.
Disconnect the battery wires from the unit before removing the battery.
Replace the battery and reconnect the wires securely.
Close the battery door to finish the replacement process.
Release tabs and slide off the battery door to access the battery.
Disconnect the battery wires from the unit before removing the battery.
Replace the battery and reconnect the wires securely.
Close the battery door to finish the replacement process.
To Next Page