Salt20 Pocket Salinity Tester Instruction Manual
1. Battery Installation
Please install batteries according to the following steps. Please note polarity:
“+” (anode) is upward; “-” (cathode) is downward
Note: This salinity meter measures practical salinity converted from electrical
conductivity (NaCl Concentration). It does not measure absolute salinity.
2. Keypad Functions
■Short press------- < 2 seconds
■Long press-------- > 2 seconds
1. Short press to turn on, long press to turn off;
2. When turned off, long press to enter setup;
3. In mode setting, short press to change
parameter;
1. When turned on, long press to enter
calibration mode.
2. In calibration mode, short press to confirm
calibration;
3. In mode setting, short press to confirm
parameter selection.
To Next Page
Loading...
