General Cautions and Warnings
Observe the following when installing or operating any PacketWave System components.
Carefully follow all local building and electrical codes, especially the latest revision of
the National Electrical Code (NEC) and standard safety procedures for installing and
working with this type of equipment. Improper procedures or installation can result in
damage to the equipment or the building, and injury or death. If you are not sure
about whether the installation follows these codes, contact a licensed building inspec-
tor or electrician in the area for assistance.
Always use quality components—including cables, connectors, mounts, etc.—
specifically rated for your particular environmental conditions and system
performance requirements.
Always use appropriate tools, and follow the instructions of the tool manufacturers.
All outdoor installation, including equipment mounting and cabling, should be per-
formed by trained microwave radio technicians familiar with usual and customary
practices and procedures.
Take extreme care to avoid contacting any overhead power lines, lights, and power cir-
cuits while you are installing outdoor equipment. Contact with any of these objects
could cause injury or death. Do not install outdoor equipment near power lines.
Observe all customary and mandatory safety requirements when installing and oper-
ating PacketWave equipment.
Because Aperto cannot be responsible for improper installation or use of its equipment,
failure to follow these and other published cautions and warnings may void your equip-
ment warranty.
To Next Page
Loading...
Need help?
General