Need help?Do you have a question about the Apex Digital SD1 and is the answer not in the manual?
General| Brand | Apex Digital |
|---|---|
| Model | SD1 |
| Category | Indoor Furnishing |
| Language | English |
Assemble two main shelf supports onto legs and tighten bolts, noting height adjustment options.
Attach bottom cross-support, upper rack supports, and monitor shelf support between legs.
Attach the keyboard shelf support bracket to the main structure and tighten bolts.
Place keyboard shelf in brackets and secure with bolts, adjusting tension.
Center shelves on support brackets and mount using provided wood screws.
Attach main legs with bottom cross-support and upper 4U rack, tightening bolts.
Secure the keyboard shelf support bracket to the structure using bolts.
Mount the keyboard shelf in its brackets and secure, adjusting pull-out tension.
Fasten small shelf brackets onto the lower cross brace.
Attach the lower shelf onto the previously mounted brackets.
Center shelves for desired depth and mount them with wood screws.
Assemble the individual monitor support wings according to the provided illustrations.
Attach the assembled monitor wings to the main desk supports at designated points.
Loosen thumbscrews on monitor wing supports to set desired heights.
Assemble the side panels and cross bar supports, ensuring bolts are tightened.
Secure the table top onto the assembled structure using the provided wood screws.
To Next Page
