51
Figure 69
NOTE 1: If none of the USB flash drive being detected before completing a sterilization
cycle, 2 warming messages “E105: No USB memory” followed by a buzzer alarm
are presented. The warning messages do not affect the operation of recording
work. Refer to “7.5.2.4 Download” for the further instructions to download the data
onto a USB flash drive.
NOTE 2: You may insert a USB flash drive before completing a sterilization cycle. Use a
USB flash drive as the storage medium is highly recommended by the
manufacturer, and always backup your USB flash drive to a secure zone.
7.5.1.3 Adjusting mode
Press “SET” button for adjusting the parameters of the recorder while in the stand-by mode.
Figure 70 – Set manual
NOTE:
1. The recorder returns to default stand-by mode after 15 seconds without any key
been pressed in the “Set” manual.
2. The recorder returns to Set manual after 15 seconds without any key been pressed.
To Next Page
Loading...
