EasyManua.ls Logo

APH Chameleon 20 - Chameleon 20 Power and Charging; Charging the Chameleon 20; Powering On and Off the Device

APH Chameleon 20
45 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
9
Rear Edge
The rear edge only contains an SD card port located near the left edge of
the device. This port allows you to insert SD cards for external storage.
Bottom Side
In each corner underneath your Chameleon are four anti-slip pads.
In the middle, closer to the front edge is a slightly indented rectangle with
a different texture. In this rectangle is a sticker containing printed hardware
information about your Chameleon. Above the sticker, there is a braille label
containing the serial number of your device.
Towards the back left of the device is the battery compartment. It is closed
and secured with two Phillips-head screws.
Charging Chameleon 20
Prior to using your Chameleon, make sure it is charged completely.
Connect the USB-C end of the recharge cable to the USB-C port located on
the left edge of your Chameleon. Minimal effort is required and forcing the
connection can damage the cable or the device.
Connect the USB-A end of the recharge cable to the power adapter, then
plug the power adapter into a power outlet. Use the provided power adapter
for optimal recharge.
Alternatively, you can charge the device using your computer and the
USB-A to USB-C recharge cable, but note that this method of charging is
slower than charging with a power adaptor.
Powering On and Off
The Power button is on the left edge of the Chameleon. It is oval-shaped
with a raised Dot in the center.
If your device is charged, press and hold the Power button for approximately
2 seconds to power on the Chameleon. There is a quick vibration and

Table of Contents