Need help?Do you have a question about the Apogee JAM and is the answer not in the manual?
General| Connectivity | USB |
|---|---|
| Compatibility | Mac, Windows, iOS |
| Input | 1/4" instrument input |
| Resolution | 24-bit |
| Bit Depth | 24-bit |
| Frequency Response | 20Hz - 20kHz |
| Type | Guitar Input |
| Power | USB bus-powered |
| Sample Rate | 48 kHz |
Plug JAM into iPad using the dock cable and connect your guitar to the 1/4" input.
Verify the JAM status light: Blue (connected, not ready), Green (ready), Red (gain too high).
Launch GarageBand, choose New Song, and select Guitar Amp.
Turn monitor ON, connect headphones, and click the Record button to start recording.
Plug JAM into Mac using the USB cable and connect your guitar to the 1/4" input.
Verify the JAM status light: Blue (connected, not ready), Green (ready), Red (gain too high).
Launch GarageBand, create Electric Guitar project, name and save it.
Set JAM as Audio Input and Built-In Output in GarageBand Preferences > Audio/Midi.
Enable monitoring, connect headphones, and click the Record button to start recording.
To Next Page
