DEPLOYMENT AND INSTALLATION
Apogee MQ series quantum meters are designed for spot-check measurements, and calculation of daily light
integral (DLI; total number of photons incident on a planar surface over the course of a day) through the built-in
logging feature. To accurately measure PFFD incident on a horizontal surface, the sensor must be level. The AL-100
accessory leveling plate is recommended for use with the MQ-210 to ensure the sensor is level when attached to a
cross-arm. The bubble-level in the plate makes leveling simple and accurate.
The AM-320 Saltwater Submersible Sensor Wand accessory incorporates a mounting fixture at the end of a 40
inch segmented fiberglass wand and is well-suited for saltwater use. The wand allows the user to place the sensor
in hard reach areas such as aquariums.
To Next Page
Loading...
Need help?
General
