fort
y-six
temperature
control
clockwise to engage
the refrigerant
compressor. At
this
time both the
air recirculating
system and
the refrigerant system
will be in
operation
to provide
you with
filtered, dehumidified,
cold air in the
volume
you desire.
4.
To operate
as a dehumidifier.
In some areas of
the nation
where
high
relative
humidities
are experienced, it
is
desirable
to operate
your unit pri-
marily for
humidity contol.
To operate
your Coleman
RV air
conditioner
as
a
dehumidifier,
set the selector switch
to the maximum clockwise
position. ln
this
position, the
indicator will be at
the minimum end of the cooling
area of
the
selector switch.
Then set the temperature
control to the lowest
position
where
the
compressor
will operate. When operated
in this position, your
Cole-
man RV
air conditioner will
remove high quantities
of moisture from the air
in
your
home without over cooling
in
the
home.
At any time the
unit is operated on either
full cooling or as a humidity
control
appliance,
the excess
moisture removed from the
air stream in your home
will
be diverted
onto the roof
of your vehicle. Do not
be alarmed as this excess
moisture
is allowed to escape
from the area of the
air conditioner
to the
ground.
CITY POWER
If you are hooked up to City Power,
make sure the air conditioner
circuit
breaker is “ON”. This breaker is located in the
bedroom overhead cabinet
on
the roadside.
4000 & 6500 WATT GENERATOR
POWER
Make sure
Air Conditioner(s) is turned
“OFF”. Start generator as per Power
Plant instructions.
Make sure
circuit
breaker,
located inside Power Plant
compartment,
is
“ON”
and that generator
main is on, located in the
bed-
room overhead
cabinet on the roadside.
NOTE: Optional rear air conditioner,
blender
&
vacuum
cleaner are powered
by generator only.
Circuit breaker is located
in generator
compart-
ment. Generator may
be run while on city power
in order to
operate
these
items. Leave
switch
on
City Power.
To Next Page
Loading...