CAUTION
● If the motor has stopped please carefully check for debris that may be obstructing or entangled in the propeller
area. Please ensure the debris is completely cleared away prior to resetting and reactivating the motor otherwise
damage may occur.
apollo underwater scooter has a built-in safety device that protects the motor if overloading occurs.
For example if rope gets wound around the propeller shaft the scooter will automatically stop.
The scooter safety sensor protects the diver's safety from rotation rebound if the propeller becomes entangled or
otherwise obstructed.
The scooter is equipped with a safety sensor to protect the motor from burn out and deterioration caused by
overloading.
If the safety device is activated, turn off the main switch once and it will be reset.
After resetting, the motor should works as usual.
apollo underwater scooter speed is controlled by the rotational speed of the propeller with the accelerator unit
and by adjustment of the propellers pitch. The rotational speed of the propeller rises when the accelerator lever is
pulled up. The rotational speed decreases when the accelerator is pushed down.
■STEP1 Accelerator operation
How to operate.
Pull out accelerator Push down accelerator
Overload protection safety sensor
(All apollo DPV)
19
To Next Page
Loading...
Need help?
General
