Apollo Metis - Battery Management and Installation; Battery Power Down; Battery Fitting and Removal

11
Turn off the power
during riding
Battery pack voltage too
low
Check battery pack output voltage. If its output
voltage is lower than 20V, please charge the
battery.
Over current protection
Remove battery pack from its frame and check
motor controller is broken or not.
Battery capacity remaining indication
If you press the ‘SOC’ button, the LEDs will indicate the ‘state of charge’ (remaining total
capacity) of the battery, against its capacity when new.
Remaining total capacity
LED 1 Flashing : < 10% SOC
LED 1 ON : 11% ~ 25% SOC
LED 1 ~ LED 2 ON : 26% ~ 50% SOC
LED 1 ~ LED 3 ON : 51% ~ 75% SOC
LED 1 ~ LED 4 ON : 76% ~ 100%
Battery complete shut down
To completely shut down the battery press the ‘Power/SOC’ button the battery
management system will enter the power off mode.