F1 is reported when the power-on brake self-test fails.
E1 is reported when a brake error occurs during opera-
tion.
Solutions:
Ensure that the brake switch and the regen throttles are
properly connected.
For full troubleshooting video library, visit our
help centre at apolloscooters.co/support
F2 is reported when the power-on throttle self-test fails.
E2 is reported when a throttle error occurs during
operation.
Solutions:
Ensure that the throttle connector is properly connected.
Replace the throttle switch, if the error code goes away,
the throttle was faulty.
If the problem persist, check whether the switch-to-inser-
tion sequence and the output voltage of the switch Hall
are abnormal.
The controller to display communication is not working
properly.
Solution:
Replace the communication cable between the display
and the controller. If the error is fixed, the connection line
is short-circuited or broken, and it can be replaced.
If the error is still reported, it is considered to be a hard-
ware failure of the display or controller.
If the error persist the display or the controller will need
to be replaced.
TROUBLESHOOTING
Please note Error codes
BRAKE ERROR THROTTLE FAILURE COMMUNICATION FAILURE
E1 F1 E2 F2 E3
Your scooter comes with a built-in communi-
cation system that allows for quicker diagno-
sis of common issues. Please consult the next
table for a classification of codes.
f the problem persist, check whether the switch-to-inser-
tion sequence and the output voltage of the switch Hall
are abnormal.
28
Replace the brake switch, if the error code goes away, the
switch/brake handle was faulty.
To Next Page
Loading...
Need help?
General
