3. DOOR RAISES BUT WILL NOT CLOSE (CLAMP).
g. Make sure LED6 and LED7 are not lit.
h. Make sure contact magnets are in proper alignment for clamping. They are located on
the front left of tub above the 24 volt box. There should be only a maximum of ¾”
between sensors on the tub and the sensor on the top bar frame.
i. If all these items check to be ok, call Apollo customer service for further assistance.
4. WHIRLPOOL PUMP DOES NOT START WHEN BUTTON IS PUSHED.
a. Make sure the water is above the front water level sensor, located on the front of the
foot well.
To Next Page
Loading...
