ApooDr ASF16-18H2A - User Manual

Questions and Answers

J
jasonpayneAug 19, 2025
What to do if my ApooDr ASF16-18H2A Air Conditioner is not working?
- S
  stricklandmichaelAug 19, 2025
  If your ApooDr Air Conditioner isn't working, consider these possible causes: * Power failure: Wait for the power to be restored. * Power is off: Turn the power on. * Blown fuse: Replace the fuse. * Dead remote control batteries: Replace the batteries. * Unit's 3-minute protection activated: Wait three minutes after restarting the unit. * Timer activated: Turn the timer off.
P
Patricia HernandezAug 29, 2025
Why does my ApooDr ASF16-18H2A Air Conditioner start and stop frequently?
- J
  Jack ClarkAug 29, 2025
  Frequent starting and stopping of your ApooDr Air Conditioner can be due to: * Too much or too little refrigerant: Check for leaks and recharge the system with refrigerant. * Incompressible gas or moisture in the system: Evacuate and recharge the system with refrigerant. * Broken compressor: Replace the compressor. * Voltage issues: Install a manostat to regulate the voltage.
J
Johnathan DoyleNov 8, 2025
Why is my ApooDr Air Conditioner not cooling properly?
- G
  gpattonNov 9, 2025
  Several factors can cause poor cooling performance in your ApooDr Air Conditioner. These include: * Temperature setting being too high: Lower the temperature setting below the ambient room temperature. * Dirty heat exchanger: Clean the heat exchanger on the indoor or outdoor unit. * Dirty air filter: Remove and clean the air filter according to the instructions. * Blocked air inlet or outlet: Turn off the unit, remove any obstructions, and turn it back on. * Open doors and windows: Ensure all doors and windows are closed during operation. * Excessive heat from sunlight: Close windows and curtains during periods of high heat. * Too many heat sources: Reduce the number of heat sources in the room. * Low refrigerant: Check for leaks, reseal if necessary, and top off the refri...

Summary

Installation Manual

Installation Summary - Indoor Unit

Indoor Unit Installation

Detailed instructions for selecting location, mounting, and connecting the indoor unit.

Outdoor Unit Installation

Instructions for selecting location and anchoring the outdoor unit.

Refrigerant Piping Connection

Steps for cutting, flaring, and connecting refrigerant pipes.

Air Evacuation

Procedure for removing non-condensable gases and moisture from the system.

Electrical and Gas Leak Checks

Steps for performing electrical safety checks and gas leak tests.

Test Run

Instructions for performing the final operational test of the unit.

Safety Precautions

Warnings for Product Use

Important safety warnings and precautions for operating the air conditioner.

Cleaning and Maintenance Warnings

Electrical Warnings

Critical safety warnings regarding electrical connections and handling.

Warnings for Product Installation

Safety precautions to be followed during the installation process.

Warning for Using R32;R290 Refrigerant

Care and Maintenance

Cleaning Your Indoor Unit

Cleaning Your Air Filter

Troubleshooting

Common Issues

Poor Cooling Performance

The unit is not working

Indicator lamps continue flashing

ApooDr ASF16-18H2A Specifications

General

Type	Split System
Heating Capacity	18000 BTU/h
Refrigerant	R410A
Outdoor Unit Noise Level	52 dB(A)
Power Supply	220-240V, 50Hz
Operating Temperature (Cooling)	18°C to 43°C
Operating Temperature (Heating)	-15°C to 24°C

Related product manuals

ApooDr ASF16-18H2B

38 pages

ApooDr ASF16-12H1A