APPA 506 - Data Logger Function; Using the Data Logger

506/506B
EN
Data Logger
You can record a lot of reading to memory in a long time,
then analyze and plot graph. The meter can store maximum
40,000 data in memory. The recorded data amount shows
on the secondary display.
The record rate can be set from 1 sec and 600 sec. The
error of timer is less than 3 seconds per hour.
To use data logger, move the blink cursor of menu to LOG
position, and press the ENTER button to enter mode. In this
mode, you can operate the below options :
To exit data logger, press the CANCEL button.
Data Logger Options
SAVE
LOAD
CLR
RATE
MAX
MIN
Press ENTER button to start data logger. The logger
automatically records at regular intervals. You can press
ENTER button to pause data
logger, press again to continue. To stop data
logger, press CANCEL button to return.
You can press the ENTER button to review data from
memory. Press UP or DOWN button to select data. Press
the CANCEL button to return.
You can setup the record rate of logger.
Press UP or DOWN button to select rate.
Press the CANCEL button to return.
Press ENTER button to review the maximum data from
memory.
Press ENTER button to review the minimum data from
memory.
Press ENTER button to clear all data from memory.
18