Need help?Do you have a question about the APPA 605 and is the answer not in the manual?
General| Type | Digital Multimeter |
|---|---|
| Display | LCD |
| Display Count | 6000 |
| Max DC Voltage | 1000 V |
| Max AC Voltage | 750 V |
| Max Current | 10 A |
| Max Resistance | 60 MΩ |
| Max Frequency | 10MHz |
| Continuity Test | Yes |
| Diode Test | Yes |
| Auto Ranging | Yes |
| Data Hold | Yes |
| Backlight | Yes |
| Safety Category | CAT III 1000V, CAT IV 600V |
| Power Supply | 9V battery |
| Temperature Range | -40°C to 1000°C |
Critical safety warnings and precautions to prevent harm, death, or equipment damage.
Step-by-step guide for measuring earth-bond resistance, including test preparation and lock mode.
Procedure for measuring insulation resistance, including voltage checks, lock mode, and discharge.
Procedure for measuring Polarization Index (PI) and Dielectric Absorption Ratio (DAR).
Instructions and cautions for replacing batteries and fuses, including correct types and procedures.
Accuracy details for earth-bond and insulation resistance measurements.
To Next Page
