APPA 506 - Meter Setup and Configuration; Meter Setup Menu Options

506/506B
EN
Auto Power O󰀨
Backlight
Buzzer
Display Resolution
Setup
If you don't operate the rotary switch or buttons for a
specied time, the meter will turn o󰀨 automatically to save
the power of batteries. The default APO timer is 10 minutes.
In setup mode, you can change the APO timer.
The backlight is automatically turned on at dark
environment. The backlight mode is default auto. In setup
mode, you can set the backlight mode.
The meter equip a 2kHz tone buzzer. Valid button press:
Beep once. And invalid button press: Beep twice. In setup
mode, you can turn on or o󰀨 the buzzer. But the buzzer in
continuity check cannot be turn o󰀨.
This meter have two display resolution: normal resolution
(3¾-digit mode) and high resolution (4¾-digit mode).
The normal resolution is set to default. You can setup the
resolution in setup mode.
To use meter setup mode, move the blink cursor of menu to
SETUP position, and press the ENTER button to enter
function. Press the UP or DOWN button to select item; press
the LEFT or RIGHT to select options. When you complete
setup, press the CANCEL button to exit setup mode.
1min to 30min, or OFF
Backlight mode: Auto, ON or OFF
Buzzer ON or OFF
Auto-Hold mode ON or OFF
Continuity threshold: 10Ω to 50Ω
Display digit: Lo or Hi
Temperature default unit: °C or °F
Press ENTER to reset all setup options.
Setup Options
APO
bEEP
A.Hold
Cntin
diGit
TEMP
RESET
b.Lit
19