Safety Information
!
Understand and follow operating instructions carefully.
Use the meter only as specified in this manual; otherwise, the
protection provided by the meter may be impaired.
!
Identifies hazardous conditions and actions that could cause
BODILY HARM or DEATH
!
• When using test leads or probes, keep your fingers behind
the finger guards.
• Remove test lead from Meter before opening the battery door
or Meter case.
• Use the Meter only as specified in this manual or the
protection by the Meter might be impaired.
• Always use proper terminals, switch position, and range for
measurements.
• Do not apply more than the rated voltage, as marked on
Meter, between terminals or between any terminal and earth
ground.
• Use caution with voltages above 30 Vac rms, 42 Vac peak, or
60 Vdc. These voltages pose a shock hazard.
• To avoid false readings that can lead to electric shock and
injury, replace battery as soon as low battery indicator.
• Discharge all high-voltage capacitors before testing.
• Do not use Meter around explosive gas or vapor.
• To reduce the risk of fire or electric shock do not expose this
product to rain or moisture.
Read First
!
Identifies conditions and actions that could DAMAGE the meter
or equipment under test.
!
WARNING
WARNING
CAUTION
EN
703
To Next Page
Loading...
