APPA A17 - User Manual

Leakage Current Card
A17 Instruction
Warning
. . . . . . . . . .
. . . . . . . . . .
. . . . . . . . . .
. . . . . . . .
Safety
. . . . . . . . .
. . . . . . . . . .
. . . . . . . . . .
. . . . . . . .
. . . . . . . . .
 Read First
- Avoid working alone so assistance can
be rendered.
- Do not use test leads or the Tester if
they look damaged.
- Do not use the Tester if the Tester is
not operating properly or if it is wet.
- Use the Tester only as specified in the
Instruction card or the protection by
the Tester might be impaired.
- Use extreme caution when working
around bare conductors or bus bar.
Contact with the conductor could result
in electric shock.
Symbols as marked on the Tester
and Instruction card
 Safety Information
To ensure safe operation and service of
the Tester, follow these instructions.
Failure to observe warnings can result in
severe injury or death.

Risk of electric shock

See instruction card

DC measurement

Equipment protected by double or
reinforced insulation
Low battery

Earth

AC measurement

Conforms to EU directives
F
Application around and removal
from hazardous live conductors is
permitted
Do not discard this product or
throw away
Power On / Off
• The Meter displays Battery Capacity
when powering up. Please replace the
battery when 0% is shown.
Auto Power Off Enable /
Disable
Auto Backlight
 Caution
If the meter is used in the vicinity of equip-
ment which generates electromagnetic
interference, the display may become
unstable or the measurements show may
be subject to large errors.
ACA
Leakage Current Measurement
Clamp Meter
Auto Hold Enable / Disable
 Caution
Take sufficient care to not to apply shock,
vibration or excessive force to the jaw tips.

Summary

Safety and General Information

Read First and Safety Precautions

Essential safety instructions, warnings, and precautions for operating the clamp meter safely.

Tester Symbols Explanation

Explanation of various symbols marked on the tester and instruction card for clarity.

Jaw Tip Handling Warning

Cautionary advice regarding the proper handling of jaw tips to prevent damage or injury.

Device Operation Features

Power On;Off and Auto Backlight

Instructions for powering the device on/off and details about the auto backlight feature.

Auto Power Off and Auto Hold

How to enable/disable the auto power off and auto hold functions for efficient use.

Leakage Current Measurement Modes

Data Hold and Peak Hold

Using Data Hold and Peak Hold functions to capture and display specific readings.

Low Pass Filter Function

Utilizing the Low Pass Filter to reduce high-frequency noise during measurements.

Comparator Function

Setting and using the comparator for threshold comparisons with audible alerts.

Auto Range and Manual Range

Switching between automatic and manual range selection for optimal measurement.

Maintenance and Specifications

Maintenance and Cleaning

Guidelines for maintaining the tester, including cleaning procedures and repair warnings.

General Specifications

Details on LCD display, measuring rate, overrange, auto power off, and battery requirements.

Environmental and Electrical Specs

Information on operating/storage conditions, altitude, conductor size, and EMC/overvoltage standards.

Electrical Specifications: Current

Detailed accuracy specifications for various current ranges and frequency response.

Low Pass Filter Specifications

Accuracy and attenuation characteristics for the Low Pass Filter function.

Limited Warranty

Information on the product's warranty period, coverage, and limitations.

APPA A17 Specifications

General

Category	Measuring Instruments
Type	Digital Multimeter
Continuity Test	Yes
Diode Test	Yes
Data Hold	Yes
Relative Mode	Yes
DC Current Ranges	10A
AC Current Ranges	10A
Capacitance Ranges	40nF, 400nF, 4µF, 40µF
Auto/Manual Ranging	Yes
Safety Category	CAT III
Current Measurement Range	600μA to 10A