No
picture
appears
on
the
SO"eCIl.
Try adjusting the
contrast
knob
Of
the
brightness
knob
on
your
monitor.
If
these adjustments
don't
help,
make
sure
your
monitor
is
• Turned
on
•
Connected
to
the
computer
• Plugged in.
The
power
Ught
above
thc
keyboard
doesn't
light.
Is
the Apple lIe plugged
in?
If
you're using a
power
strip,
make
sure
the powcr strip is plugged
in
and
rumed on. Is the wall outlet
connected
to
an
on-off switch?
A
screen
for
a
program
other
thanA"
11ltmdlld/()tl
appc:tr.>.
Did you insert the correct disk? Check that the label reads
An
Introduction.
TIIC
"wrong~
disk
drive actlvatcs.
The disk drive that starts
when
you rurn
on
the
power
is
drive
1.
Turn
off the power,
put
the Introduction disk in the drive that started (the
true drive
1),
and
begin again.
If you want a diJTercm drive to act as drive
1,
you
need
to change the
position
of
the
disk relative to
the
controller card.
The
drive that
connects directly to
the
controller card
is
drive 1 for that controller
card's
SIOl
The drive daisy-chained
to
the first drive is drive
2,
and
so
on.
If
you have illStalled more than
one
controller card,
you
may also
need
10
rearrange
the
positions
of
these cards.
SCe
"Choosing Disk
Drive Controller Slots"
in
Chapter
1.
TIle
disk
drive
lightstays
on
for
an
lnordinalcly
long
time.
You can stop the disk drive
by
holding
down
Control while you
press Reset. (Whenever you press a Reset
key
combination, always
release Reset first
or
the combination might not
work.)
Remove
the
disk.
Is
it
the correct disk? Consult Appendix C for further help.
30
Chapter
2:
Starting
the
Apple
lie
To Next Page
Loading...
