Apple IIe - Page 203

Cassette
and
Disk Storage with
the
Apple lie 203
Configuration
SAVE
filename
[Sx,
Vx, Dx]
When
SAVE
is
executed,
the
specified
drive
will
begin
spinning
and
the
in use
lamp
will
light.
This indicates that
the
program
in
RAM
is
being
saved
on
diskette.
When
the
drive
stops
spinning
and
the
in-use
light
goes
off,
the
prompt
will
reappear. The
program
will
have been saved
on
diskette.
If
a
filename
is
specified
with
SAVE
that
is
identical
to
a
filename
already
on
diskette,
the
file
being
saved
will
replace
the
file
on
diskette. The
original
file
will
be erased.
DELETE
The
DELETE
command
can
be
used
to
remove a
file
from
a
diskette.
Configuration
DELETE
filename
[,
Sx,
Vx, Dx]
RENAME
The RENAME
command
can be used
to
change
the
name
of
a
diskette
file.
Configuration
RENAME
oldfilename,
newfilename
The
file
specified by
oldname
will
be
renamed
as
specified in
newname.
If
newfilename
specifies a filename already
on
diskette,
DOS
will
still
change
the
filename
as
indicated by
RENAME.
As
a
result,
two
files
could
be located
on
the
same
diskette
with
the
same
filename.
To
prevent
confusion,
avoid
using
the
same
filename
for
files located
on
the
same diskette.
If
a
file
is
locked
,
it
cannot be renamed. Exercise caution
when