Apple IIe - Page 202

, 202 Apple lie Users Handbook
FILE NOT FOUND
If you are changing the name of your greetings program , be sure
to rename the program 's filename as described in Step 3.
LOAD
LOAD is used in DOS to load a program file from diskette into
memory .
Configuration
LOAD filename [Sx, Vx, Dx]
The
following example would load the program file named
JiROGA
from diskette into memory:
LOAD PROGA
If the specified filename cannot be located in the diskette
directory, the following message will be displayed:
FILE NOT FOUND
If the file is located on the directory , DOS will check to be sure
that the file is a program file. If the specified file is not a program
file , the following message will be displayed:
FILE TYPE MISMATCH
If the specified file is located in the directory and it is a program
file, the current program in RAM will be erased and the specified
program file will be copied from the diskette file into RAM . That
program can then be edited, renamed, listed, or run .
SAVE
The SAVE command is used in DOS to save a program from RAM
onto diskette.