Apple IIe - Page 210

210 Apple lie Users Handbook
This program (named CREA TE EXEC) will create an EXEC file
named SAMPLE. Note on line 130 that the DOS command
CATALOG need not be preceded by CTRL-D. This is the c ase
with other DOS commands as well.
Once CREATE EXEC has been saved on diskette, the following
command:
RUN CREATE EXEC
will result in the creation of an EXEC file named SAMPLE. This file
can then be executed with the following command :
EXEC SAMPLE
BSA VE
DOS allows the usage of binary files as well as BASIC program
files. Binary files are denoted with the letter Bin catalog listings.
BSA VE is used to save a binary file on disk.
Configuration
BSAVE filename , Axxx, Lxx , [ Sx , Vx, Dx ]
A indicates
the beginning address in memory of the data to be
stored
on diskette. If A is specified in hexadecimal notation , it
should be preceded with the dollar sign ($). The address
specified
with A (xxx) should correspond to an actual memory
address in the lie .
L indicates
the length in bytes of the portion to be saved. The
maximum number of bytes that can be saved is 32767 .
BLOAD
BLOAD loads the contents of a binary file back into memory .