250 Macintosh
User's
Handbook
The cross connection in the center should be bypassed. In
order
to
repair this, draw a small circle slightly larger
than
the
contact point
and
center it over the crossed connection. Erase
the left half
of
it
and
redraw the lines as shown in figure
7.41
to
give the "jumping over" impression.
The labels are
drawn
in two parts. The main symbol
designation appears in
12
point while all subscripts
but
those
for
Vi
and V
0
are 9 point. Since all subscripts are slightly below
the main symbol, they will require separate insertion point
placements. For C
2
and Rbs' it may be necessary to create the
labels in a more
open
area
and
then use the lasso to move them
into place. Refer
to
figure 7.42 for the final version. Inciden-
tally, this circuit
is
called a bootstrap biased common emitter
amplifier.
CONCLUSIONS
This example relied heavily on copying and manipulating
component
parts
of
the diagram. The task could have been
quite tedious without those functions, but it was almost trivial
with them. This concludes the examples using text. The final
example discusses a simple method
of
artistic drawing.
To Next Page
Loading...
