Apple iMac G5 Memory, 17-inch User Manual

iMac G5 Memory, 17-inch Rev. B

iMac G5
Memory, 17-inch
Replacement Instructions
Follow the instructions in this sheet carefully. Failure to follow these instructions could
damage your equipment and void its warranty.
Online instructions are available at http://www.apple.com/support/doityourself/.
Tools Required
• Use a Phillips #2 screwdriver
Part Location

Apple iMac G5 Memory, 17-inch Specifications

General

Model	iMac G5
Screen Size	17-inch
Processor	PowerPC G5
Memory Type	DDR SDRAM
Memory Slots	2
Maximum Memory	2 GB
Installed RAM	256 MB or 512 MB
Storage	80 GB or 160 GB HDD
Graphics	ATI Radeon 9600
Operating System	Mac OS X

Summary

Tools and Preparation

Tools Required

Identifies the single tool needed for the memory replacement procedure: a Phillips #2 screwdriver.

Part Location Overview

Visual guide indicating the location of the memory modules within the iMac G5.

About iMac G5 Memory Specifications

Memory Module Compatibility

Details the required criteria for DIMMs, including type, voltage, and pin count, and maximum capacity.

Unsupported Memory Features

Lists features not supported in iMac G5 memory modules, such as ECC and parity.

Opening the iMac G5

Power Down and Disconnect

Instructions to shut down the computer and disconnect all cables and the power cord.

Positioning for Access

Guidance on placing the computer face down on a soft surface to prepare for opening.

Removing the Back Cover

Steps to loosen captive screws and lift off the computer's back cover.

Removing Existing Memory

Grounding Procedure

Essential step to discharge static electricity by touching a metal surface inside the computer.

Locating and Releasing Memory

Instructions to find memory modules and release them by pushing side latches.

Installing New Memory

Preparing the New Module

Remove the replacement memory module from its packaging.

Inserting the Module

Align the notch and firmly press the module into the slot until it clicks.

Closing the iMac G5

Aligning the Cover

Mate the slots on the cover's top edge with the tabs on the display housing.

Securing the Case

Tighten the case screws, starting with the middle one, to properly seat the display/bezel.

Final Connections and Power On

Reconnect the power cord and turn on the computer in its upright position.