Apple Power Mac G4 - Page 273

Upgrades AirPort Card - 6
2. Insert the AirPort card,
barcode side facing up,
through the opening in
the PCI card guide and
into the connector on the
logic board.
3. Connect the antenna
cable to the conector on
the end of the AirPort
card.
Important:
After installing
an AirPort card on a new,
out-of-the-box Power Mac
G4 running Mac OS 9, you
must press Option-S when
restarting the computer.
This ensures the customer
Plug the 
antenna wire 
into the hole 
in the end of the 
AirPort Card.
The antenna 
wire is stowed
here when not

in use.
AirPort Card
(Barcode side
should face up.)