Contents
Introduction ----------------- 2
Hardware Requirements ----------------- 2
Hardware Setup ----------------- 2
CA100 Equipment Setup ----------------- 3
Software Requirements ----------------- 3
Alignment Condition Requirements ----------------- 3
Alignment Procedures ----------------- 4
Turning ON the unit ----------------- 4
Data Upload ----------------- 4
Data Download ----------------- 4
B+ voltage check and adjustment ----------------- 4
USB output voltage check ----------------- 5
1V check and adjustment ----------------- 5
Raster centering ----------------- 5
Regulation check and adjustment ----------------- 5
CG check and adjustment ----------------- 5
Focus check and adjustment ----------------- 5
Beam Landing check and adjustment ----------------- 6
Geometry check and adjustment ----------------- 6
White balance check and adjustment ----------------- 6
VPT check and calibration ----------------- 8
EDID Data Check ----------------- 9
Theater Mode Check ----------------- 9
Bright Window Check ----------------- 9
Degauss Check ----------------- 10
Turning OFF the UUT ----------------- 10
APPENDIX A
Description of buttons functions in [Geometry] page 11
Description of buttons functions in [Color/Convergence] page 11
Description of menu functions 12
APPENDIX B
Wiring diagram for CA100 and 801GF to Mac serial port 14
To Next Page
Loading...
