3
CA100 Equipment Setup
1. Check that the CA100 has been set to FL.
2. Check that the baud rate has been set to 2400.
3. Connect the DB25 connector of the serial cable to the CA100 RS232 terminal and the
DIN 8 to the Mac serial modem port.
4. The Minolta color analyzer CA100 must be calibrated with a high accuracy
colorimeter (e.g. LMT) or photometer for the following color temperature in the
memory channels:
• Channel 1 = 4100.
• Channel 2 = 5000.
• Channel 3 = 6500.
• Channel 5 = 9300.
• Channel 6 = Red.
• Channel 7 = Green.
• Channel 8 = Blue.
Software Requirements
1. Mac OS 8.6 or above.
2. USB card support drivers version 1.1 drivers or above.
3. Apple monitors (version 2.0.3) - Tobiko software.
4. Apple Mac Cabernet rework software.
Alignment Condition Requirements
1. Unit-under-test (UUT) must be in burn-in with full white pattern (generated from
power brick when no external video signal is sensed) for a minimum of 30 minutes.
2. UUT must be properly degaussed before any alignment.
3. Alignment must be done in the helmholtz cage.
To Next Page
Loading...
