4 -
Studio Display (17" ADC) Take Apart
Monitor Stand
Monitor Stand
Note:
The monitor stand is a customer-installable part and its replacement is covered by
the Customer Installable Parts (CIP) program. The following replacement procedure is
packed in-the-box with all replacement monitor stands.
Be sure to follow the instructions in this sheet carefully. Failure to follow these instructions
could result in damage to your equipment and may void your warranty.
Replacing your monitor stand requires five basic steps:
• Turn off the computer and disconnect the display cable.
• Place the monitor upside down on a thick cloth.
• Remove the monitor stand.
• Install the replacement monitor stand.
• Place the monitor upright, connect the display cable, and restart the computer.
Note:
Written and video instructions covering customer-installable parts are available at
http://www.info.apple.com/installparts/.
Tools
Two jeweler’s flat-blade screwdrivers are required for this procedure.
Note:
If you do not have jeweler’s screwdrivers, two long carpenter’s nails can be used.
However, the head of the nail must be at least 6 mm wide to prevent the nail from sliding
into the enclosure.
Warning: If any tools or parts drop into the monitor, do not turn on the monitor.
Contact Apple for further assistance. Never turn on your monitor unless all of its
internal and external parts are in place and it is closed. Operating the monitor when
it is open or missing parts can damage your monitor or cause injury.
Preliminary Steps
No preliminary steps are required before you begin this procedure.
To Next Page
Loading...
