Apple Video Card User Manual

073-0562 Rev. G
 Power Mac G4 / Macintosh Server G4
Video Card
Replacement Instructions
Follow the instructions in this sheet carefully. Failure to follow these instructions could
damage your equipment and void its warranty.
Note: Written and video instructions covering customer-installable parts are available at
http://www.info.apple.com/installparts/.
Warning: During this procedure, keep small parts away from children.
Tools Required
• Phillips screwdriver
• Pliers
Opening the Computer
Warning: Always turn off your computer before opening it to avoid damaging its
internal components.
1. Place your computer on a clean, flat surface.
2. If you think your computer is in sleep, press the power button on the front of the
computer to wake it.
3. Shut down your computer by opening the Special menu and choosing Shut Down.
Then wait five minutes for the computer’s internal components to cool down.
4. If you attached a security cable through the computer’s lockable cover latch, remove
the cable.
5. Unplug all other cables from the computer except the power cord.

Apple Video Card Specifications

General

Brand	Apple
Model	Video Card
Category	Network Card
Language	English

Summary

Tools Required for Video Card Replacement

Opening the Computer for Access

Removing the Installed Video Card

Removing a PCI Video Card

Gently pull up the card and remove it from its PCI expansion slot.

Removing an AGP Video Card

Pull back the retaining clip tab and lift the AGP card straight up out of the connector.

Installing the Replacement Video Card

Attaching the Fence to the Card

Install the fence using Phillips and jack-nut screws on the ADC and VGA connectors.

Inserting the Card into the Slot

Align the card's connector with the slot and press straight down until fully inserted.

Securing the Card

Replace the card's mounting screw and tighten it to secure the card in place.

Closing the Computer After Replacement