To Next Page

To Previous Page

3.3 Headrest adjustment for Group II & III

1. Using the release handle (09), adjust the headrest (08) up or

down as required, then release the handle and the headrest

will lock into place automatically. (fig. 6)

2. If required, the headrest (08) can be further adjusted by

using the adjusting ring (07), please refer to section 3.2 for

details.

3. The headrest (08) is in the correct position when the

diagonal portion of the vehicle seatbelt (10) sits on the child’s

shoulders, a gap of about 2 fingers width between the child’s

shoulders and the lowest edge of the headrest. (fig. 7)

3.4 Recline function

1. Using the release mechanism (11), adjust the seat (12) to

the desired position then release the mechanism and the

seat will lock into place automatically. (fig. 8)

3.5 360° rotation function

1. Press the release button (13) to release the seat (12), and

then rotate the seat to the desired position. Release the

release button (13) to lock the seat (12) into place automatically.

(fig. 9)

CAUTION: The child seat can only be used in forward or

rearward facing position when travelling. Always ensure that

the rotating part of the child seat is fully engaged by trying to

turn the seat (12) around in both directions.

CAUTION: Please adjust the seat as fullest recline position

when rearward facing is in use for the child. The fullest

recline position of the seat is that the triangular sign on

seat body will match with the groove on the red belt guide.

FULL RECLINE

REARWARD

GR. 0+

APRAMO ONE User Manual

Questions and Answers: