EasyManuals Logo

APRILIA PEGASO 650 IE - PART2 11-1999 User Manual

APRILIA PEGASO 650 IE - PART2 11-1999
60 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #52 background imageLoading...
Page #52 background image
68
use and maintenance Pegaso 650
-
#(%#+).'4(%34%%2).'
Carefully read p. 61 (MAINTENANCE).
Place the vehicle on the center stand,
see p. 59 (POSITIONING THE VEHICLE
ON THE STAND).
aWARNING
Before carrying out the following opera-
tions, let the engine and the exhaust si-
lencer cool down until they reach room
temperature, in order to avoid burns.
Check the slack in the fork head after the
first 625 mi (1,000 km) and thereafter every
3,750 mi (6,000 km).
To check fork head slack:
Remove the oil pan guard (1), seep. 82
(REMOVING THE OIL PAN GUARD).
NOTE Prepare a 12.60 in (320 mm) high
support, the base of which must measure
7.87 x 7.87 in (200 x 200 mm).
Place the support (2) under the vehicle
and a soft cloth (3) between them, so
that the front wheel can move freely and
the vehicle cannot fall down.
aWARNING
Make sure that the vehicle is stable.
If it falls over, it may cause injury to by-
standers and other property, as well as
being damaged itself.
Shake the fork in the direction of travel.
NOTE Carry out this operation with
care. Do not pull the fork back and forth
too vigorously, or you may observe play in
the center stand, which would give you a
false indication of fork head slack.
Repeat this operation several times until
you are confident you have accurately as-
sessed the fork head slack.
There should be no fore and aft slack. If
you detect any slack, arrange to have
your vehicle repaired by your Local april-
ia Dealer.
#(%#+).'4(%37).').'!2-
&5,#25-3(!&4
Carefully read p. 61 (MAINTENANCE).
Every 7,500 mi (12,000 km) check the
swinging arm fulcrum shaft and needle
bearings for slacks.
To perform this check:
Place the vehicle on the center stand,
see p. 59 (POSITIONING THE VEHICLE
ON THE STAND).
aWARNING
Before caryring out the following opera-
tions, let the engine and the exhaust si-
lencer cool down until they reach room
temperature, in order to avoid burns.
Attempt to move the swinging arm verti-
cally and laterally, as shown in the illus-
tration above.
There should be no vertically and lateral-
ly slack. If you detect any slack, arrange
to have your vehicle repaired by your Lo-
cal aprilia Dealer.
Usa-01.fm Page 68 Wednesday, December 15, 1999 9:31 AM

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the APRILIA PEGASO 650 IE - PART2 11-1999 and is the answer not in the manual?

APRILIA PEGASO 650 IE - PART2 11-1999 Specifications

General IconGeneral
BrandAPRILIA
ModelPEGASO 650 IE - PART2 11-1999
CategoryMotorcycle
LanguageEnglish

Related product manuals