Advanced Printing Systems
SS205-V4+ LV - Technical Manual - Rev B Page 10
3.7. Thermistor
When performing continuous printing, it is recommended that the supply energy be reduced so that
the substrate temperature monitored through the thermistor will remain below 70°C. The thermistor
specification is the following:
- R25, resistance at 25°C: 10 KOhms +/- 5%
- B value: 3550 K +/- 3%
- Thermistor operating temperature: - 40°C to + 85°C
- Time constant: Max.30 s (in the air)
Then the resistance value, R, versus temperature, T (in °C), is given by the formula:
The dot activation compensation time (1% per degree) is defined as follows:
T on(25 ℃) is given in section 3.5
3.8. Print Position of the Data
The first bit of data (dot 1) entered is the first bit of data printed (FIFO), left side of TPH, top view
(opposite side of the printer gear box).
To Next Page
Loading...