APS SS205-V4+ LV - General Characteristics

Advanced Printing Systems
SS205-V4+ LV - Technical Manual - Rev B Page 5
2. GENERAL CHARACTERISTICS
Item
Specification
Printing method
Thermal dot line printing
Number of dots/line
384
Main scanning density (dot/mm)
8
Subsequent scanning density (line/mm)
8
Printing width (mm)
48
Paper width (mm)
58 +0/-1
Paper feed pitch (mm)
Paper pitch (mm)
0.0625(every 1 step of the motor drive signal)
0.125(every 2 step of the motor drive signal)
Paper feed tension (gf)
50 or more
Paper hold tension (gf)
80 or more
Dimension W*D*H (mm)
68 × 24 × 26
Weight (g)
Approx. 29 (printer and roller) 24.7 (printer only)
Head temperature detection
Thermistor
Paper end detection
Opto sensor
Operating voltage range
Logic: 3-5.25V / Dots : 3.0-9.5V
Current consumption
At printing(3.6V):
(64 dots ON)
1.9A (Head power) peak
55 mA (Head logic 5V)
0.65A (Motor in voltage control
mode
At paper feeding
(3.6V):
0.65A (Motor in voltage control
mode
<100uA (Head logic 5V)
Recommended Paper
(Equivalent types can be used)
PD160R
OJI PAPER MILL Co.LTD. AF50KS-E (Jujo paper)
Operating temperature range (C)
-30 ~ +75
Operating humidity (RH%)
20 ~ 90 (no condensation)
Storage temperature range (C)
-40 ~ 85
Storage humidity (RH%)
5 ~ 90 (no condensation)
Printer life
Durability
Basic conditions
Maximum variations
Thermal head
pulse resistance
200 million pulse
(12.5% duty cycle)
-Room
temp:20/50C
-Head Temp:75C
Max
-Rated energy
Max 15% average dots
Resistance value (Ohms)
from initial value
Abrasion/wear resistance
100 km of paper
* When operating temperature is less than 0C, print quality is not guaranteed.