7
END OF SEASON STORAGE:
•Follow the Cleaning and Descaling instructions when the humidifier will be stored at the end of the
season.
•Dry the humidifier completely before storing. DO NOT store with water inside the Base or Water
Tank.
•Pack the unit in its original carton and store in a cool, dry location.
NOTE: IF YOU EXPERIENCE A PROBLEM, DO NOT ATTEMPT TO OPEN THE MOTOR
HOUSING YOURSELF. DOING SO MAY VOID YOUR WARRANTY AND CAUSE DAMAGE TO
THE HUMIDIFIER OR PERSONAL INJURY
TROUBLESHOOTING GUIDE
Water vapour and
humidity are not
produced.
Power plug: Unplug and then try again.
Power Failure: When the power is returned, try again. Tank Installation: Make
sure the tank is correctly attached. The surface of the ultrasonic disk is dirty:
Clean ultrasonic disk.
Air blows but water vapor
is not produced.
Excessive Water: Remove a certain amount of water from the base.
Detergent residue and/or oil ingredients from cosmetics, etc may be in tank or
filter; wash out tank, filter and try again. The surface of the ultrasonic disk is
dirty: Clean ultrasonic disk.
If you use hard water, replace with softer water.
The surface of the ultrasonic disk is dirty: Clean ultrasonic disk.
The water in the unit is too cold: Replace with cool, but not cold water.
The humidity has a bad
smell.
Poor maintenance or dirty water: Clean the product thoroughly, and fill it with
fresh water.
White dust is forming on
nearby furniture.
Hard water may deposit a certain of dust. Dust in the air also settles because
of added humidity in the room. Use distilled water if this becomes a nuisance.
Remember to clean the filter interior surface after use for a short time.
Unit has stopped
working.
No or low water. Unplug unit and refill tank.
Water is accumulating
outside of unit or area
surrounding unit.
Saturation of humidity. Lower mist control setting.
Unit not level and water is accumulating. Unplug and place on level surface.
Point spray away from objects. Raise unit on a water-resistant level surface 2-
3 feet off of floor.
Water dripping when
refilling.
Water remaining on bottom of tank. Wipe tank or tilt to drain before
transporting.
Unit must be placed on a flat, level, hard surface. Make sure it is NOT placed
on a soft or absorbent surface.
Red light on power
button.
Indicates low water. Unplug and refill tank.
Water dripping when
refilling.
Water remaining on bottom of tank. Wipe tank or tilt to drain before
transporting.
Unit must be placed on a flat, level, hard surface. Make sure it is NOT placed
on a soft or absorbent surface.
Red light on power
button.
Indicates low water. Unplug and refill tank.
To Next Page
Loading...