Note :
If there is no water in the water tank, the red indicator light on the Power Button will be on and the
display shows E1.
If the water tank is lifted up during working, the red indicator light on the Power Button will be on and
the display shows E2.
If the room humidity under 30%, display show Lo, If the room humidity over 80%, display show HI.
The button is invalid when the humidifier valve is opened to add water or the humidifier water tank is
picked up.
CLEANING AND MAINTENANCE
•Always unplug the unit before servicing in any way.
•Inside the base of the unit. Pour excess water out of the unit. Wash out the unit with fresh water
using the cleaning brush and a soft cloth as needed. Do not submerse the base of the unit into
water, or allow water to enter inside through the air inlets or air outlet.
•Water tank. Empty water tank. Remove top cover and clean the inside of the tank with fresh water,
vinegar solution or dish washing liquid and cloth or light brush (bottle cleaning brush is
recommended). Rinse after cleaning with fresh water.
•Outer surface of the unit. Wipe the surface of the unit with a soft, damp cloth if needed. If you
notice an accumulation of water during usage, reduce humidity and dry outer surface with a cloth.
DESCALING:
•Depending on usage and water type, cleaning to remove scale may be required weekly or every
other week to optimize unit performance.
•If you live in a hard water area, we recommend the use of distilled water for your humidifier. This
will help reduce the precipitation of minerals or ‘white dust’.
1.Fill the Base with: mixture of 1 tsp. white vinegar and 1 tsp. Water.
2.Let solution stand for 5 minutes.
3.With the vinegar in the Base, clean all interior surfaces with a soft cloth or brush to help remove
scale.
4.Also check mist nozzle, filter and mist tube in water tank. Clean as needed.
5.Rinse the Base thoroughly with water to remove scale and vinegar solution
Warning:
•Do not clean the unit or water tank with cleaning chemicals of any kind as they may contain bleach.
Use dish washing liquid or vinegar solution only.
ULTRASONIC DISK:
1.Unplug unit.
2.Remove the tank and empty all water from unit base and tank.
3.Locate the ultrasonic disk on the inside center of the base unit.
4.Use ONLY the enclosed cleaning brush to gently clean disk and remove build up and deposits.
5.Drain water in the base according to the drainage direction. Make sure water won’t flow into the
Dry Air Exhaust.
Do not scrub or scrape the ultrasonic disk.
To Next Page
Loading...