Aqara E1 - Page 25

LCD screen
displays a
fault icon
6
Incorrect installation
of the thermostat
The temperature is set too high
Valve fault
The room is too large
(the radiator does not
match it) or over-ventilated
Low water inlet pressure
or temperature
Remove the thermostat from the valve,
take out the batteries and put them back
aer 30 seconds, reinstall the thermostat
and observe whether the fault persists.
Replace the batteries.
Replace the valve, take out the batteries
and put them back aer 30 seconds, and
then reinstall the thermostat.
Replace the radiator or check
whether the doors or windows are
open or not fastened.
Check the water inlet pressure and
temperature.
Note: In case of any issue not resolved, please contact the aer-sales department -
support@aqara.com
-22-