Aqara E1 - User Manual

Other manuals for Aqara E1

Manual15 pages

Questions and Answers

C
Carmen CampbellJul 28, 2025
What to do if my Aqara Thermostat LCD screen displays a 6 fault icon?
- S
  scott19Jul 29, 2025
  If the LCD screen on your Aqara Thermostat displays a '6' fault icon, there are several potential causes. First, the thermostat might not be installed correctly; try removing it from the valve, taking out the batteries, waiting 30 seconds, and then reinstalling it to see if the problem goes away. Also, the temperature might be set too high, so try replacing the batteries. There could be an issue with the valve itself, in which case you should replace the valve, remove the batteries, wait 30 seconds, and reinstall the thermostat. Finally, the room may be too large for the radiator, or it might be over-ventilated; consider replacing the radiator or ensuring that doors and windows are properly closed.
C
charlottehallAug 8, 2025
Why is my Aqara Thermostat showing a higher temperature than set?
- D
  Derek DavisAug 8, 2025
  If your Aqara Thermostat is working normally but the room temperature is evidently higher than the set temperature, it could be due to a couple of reasons. First, the thermostat might be incorrectly installed. To resolve this, remove the thermostat from the valve, take out the batteries, wait 30 seconds, and then put them back in. Reinstall the thermostat and see if the issue continues. Second, there might be a valve fault. In this case, replace the valve, remove the batteries, wait 30 seconds, and then reinstall the thermostat.
A
agordonAug 17, 2025
Why is the temperature fluctuating with my Aqara Thermostat?
- H
  hallkayleeAug 17, 2025
  If your Aqara Thermostat works normally, but the room temperature is not constant, there are a couple of potential reasons. The batteries might be low, so try replacing them. Also, the room might be over-ventilated, causing heat loss. Check to make sure that doors or windows are closed tightly.