Aqua-Base YC - Page 9

AQUABASEYFR-GB -ES 01-2007 VERSION 01/07 FR/GB/ES Page 9/9
WARNING : Read this documentation carefully in its entirety, before installation, use or maintenance of the AQUA-BASE
desalination unit. In this way you will avoid incorrect operating faults which may lead to consequences that will not be covered by the
guarantee.
SUMMARY
Page Chapter
9 1 Presentation
9 2 Characteristics
10 3 Description Water system & electrical circuit
10 4 Installation Positioning, water system connection and electrical connection
11 5 Extra Remote panel
12 6 Starting up
12 7 Utilisation ON, OFF, rinsing, preservation
13 8 Service Schedule, consumables, maintenance operations, membranes cleaning
23 9 Spare parts
21 Starting up report
26 General layout
35 Electric drawings
36 AQUA-BASE service
1. PRESENTATION
Water makers AQUA-BASE range Y is available in kit form YK, or compact form YC.
In both version, hull fitting and hull valve are not included in our scope of supply.
2. CHARACTERISTICS (See Fig.1p24 & Fig.1bisp25)
TYPE YC1 / YK1 YC2 / YK2 YC3 / YK3 YC4 / YK4
Dry mass kg 61 / 52 69 / 60 77 / 68 85 / 76
Std. capacity (2) l/h 60 120 180 240
Maximum capacity (3) l/h 70 135 200 250
Pressure (1) bar 40 to 70
Pipes
Feeding
Reject
Production
A / B / C/ D
L
I / J / K
mm
mm
mm
15 x 23
8 x 13
8 x 13
Voltage V 115/1/60 230/1/50 230/3/60 400/3/50
Elec. consumption A 25 13 8 4.5
HP pump speed Rpm 1200 1000 1200 1000
HP pump flow l/h 700 600 700 600
(1) The pressure is adjustable, to optimize performances, according to operating conditions.
(2) The nominal capacity is given for a new unit, nominal membranes performances, operating in standard sea water TDS 35000ppm (35g/l) and temperature
25°C. The capacity can vary from +/-15%, according to allowances given by the membranes manufacturers.
(3) This flow is the maximum authorized. Pressure should be adjusted in order not to exceed this : it should particularly be reduced as soon as the sea water
salinity noticeably decreases, notably at river mouths.
AQUA-BASE
kit version YK
is supplied in separated sets :
- seawater booster pump with strainer,
- 20µ and 5µ filter,
- HP pump set with coupled electric motor,
- R/O module with pressure control system,
- pipes, fittings and fixation components necessary for installation,
- technical handbook.
AQUA-BASE
compact models YC
, are supplied in a compact frame.
Only the Booster Pump is supplied in a separated set, in order to
allow its installation below the water line.