LEAKSHIELD
For Aqua Computer pumps that are not found automatically, you can select the
installed pump directly in the drop-down selection.
Other pumps can be configured via the user-defined setting. In this case you need
information about the maximum pressure of the pump and the maximum speed.
In addition, the aquasuite tries to find a data source for the speed of the pump. If
there is no selection in the data source field or if the selection is wrong, you can
correct it manually.
The pump speed is important to automatically adjust the vacuum to the operating
point of the pump.
Now go to the "Flow" section.
A flow sensor is not mandatory for the correct function of LEAKSHIELD. However, it
helps to calculate the operating point more precisely and to be able to reduce the
vacuum further.
LEAKSHIELD automatically searches for Aqua Computer flow sensors. If sensors
are found, the most useful sensor is automatically selected.
You can also make a selection manually using the "+" button or perform a new
search for sensors using the "Search Flow Sensor" function.
The next page "Pressure" allows you to skip the previously calculated values. This
function is only useful for experts and is not recommended.
The selection "Use adaptive pressure" is preselected and lets LEAKSHIELD adap-
tively calculate the optimal values at any time. If this selection is deactivated,
LEAKSHIELD works with the maximum possible pressure for the selected pump as
the operating point.
By selecting "Time controlled generation of negative pressure" you can select two
times at which LEAKSHIELD will build up the negative pressure again. This allows
you to schedule the operating noise of LEAKSHIELD at a time that does not disturb
you.
After leaving this page, you will reach the "Standby" section.
When booting from standby, no data can be sent to LEAKSHIELD via USB yet.
Therefore LEAKSHIELD needs defaults for the operating point of the pump. You
can select this data via speed and flow defaults. In addition, current values can be
taken from the assigned data source. If you do not know the data, you should not
activate a reduction of the vacuum in standby in the following option
© 2021 Aqua Computer GmbH & Co. KG - 17 -
Gelliehäuser Str. 1, 37130 Gleichen
To Next Page
Loading...
Need help?
General