10
OUT
IN
When the pump is installed outside, we recommend
providing a simple protection against the weather (rain,
sun etc.).
Caution
Caution
Implement appropriate measures to attenuate the noise
generated by the pump to avoid damage to the environment.
Fastening the pump to the foundation should be effected
exclusively by means of bolts, threads or dowels, in order to
avoid blocking the removal of the motor unit! Make sure that
there is enough space between the fan cover and the wall,
minimum 50 mm. You also need enough space to permit
disassembly of the strainer basket, minimum 210 mm above.
The pump should be installed at water
level or below water level and in a
horizontal position, in order to keep
the suction path as short as possible
and to reduce head loss. The Aqua
Plus is self-priming and should never
be installed more than 2 m above water
level. Make sure that the suction line
is not leaky, otherwise the pump will
prime insufficiently or not at all. We
recommend the installation of check
valve and shut-off valves depending on
the type of pump or unit.
The adhesive bonds in the suction and
pressure lines require more time to
cure, allow at least 12 hours before
starting the pump.
4. Installation
Caution
The installation site of the pump must be dry and well
ventilated.
When installed in a closed room, a drainage connected
to the sewers must be installed. The size of the floor
drain depends mainly on the size of the swimming pool
and the circulation flow rate but also on possible leaks
within the pool water circulation system.
The ambient temperature must not exceed 40°C.
50
210
To Next Page
Loading...
Need help?
General
