Aquabot RAPIDS XLS - Quick Start Instructions; Connect Cleaner to Power Supply; Adjust Wheels; Place in Pool and Remove Air Bubbles

QUICK START INSTRUCTIONS (Steps 1-6)
Plug the power supply into a GFCI outlet.
(Ground Fault Circuit Interrupter)
To adjust the wheels, use the ‘slider’ on the front. For more
detailed information, please see Settings Manual.
Turn power supply ON.
Place the cleaner in your pool using the front handle and
turn upside down to remove any air bubbles.
Set the timer setting and let the cleaner go!
Straighten out the floating cable and plug the cleaner into the
power supply. DO NOT plug the power supply in at this point.
1
ON / OFF
5
= 1 Hour Shut-off
= 2 Hour Shut-off
6
2
3
4