What to do if LED bulb does not light after replacing a UV lamp in Aquafine Steriliser?
If the LED bulb doesn't light after you've replaced the UV lamp, there are a few things you can check: * First, verify the electrical output of the ballast connected to the UV lamp. * If the ballast isn't working, replace it. * If the voltage reading is fine but the LED still doesn't light, replace the LED board.
Overview of SL Series models (SL-10A, SL-1, MP-2-SL) for indoor applications.
Guidance on unit placement, ventilation, vibration protection, and piping load management.
Detailed procedure for safely installing the quartz sleeves into the UV treatment chamber.
Guidance on replacing UV lamps and ballasts, including schedules and procedures.
General| Model | MP-2-SL |
|---|---|
| Category | Steriliser |
| Maximum Operating Temperature | 104°F (40°C) |
| Frequency | 50-60 Hz |
| Type | UV |
| Electrical | 120V/60Hz or 220V/50Hz |
| Inlet/Outlet | 1/2" NPT |
| Lamp Life | 9, 000 hours |
To Next Page
