To Next PageTo Next PageWhat to do if LED bulb does not light after replacing a UV lamp in Aquafine SL-1 Steriliser?
If the LED bulb doesn't light after you've replaced the UV lamp, there are a few things you can check: * First, verify the electrical output of the ballast connected to the UV lamp. * If the ballast isn't working, replace it. * If the voltage reading is fine but the LED still doesn't light, replace the LED board.
Details mandatory safety requirements for UV equipment operation and installation.
Lists conditions that will void the equipment warranty if not followed.
Emphasizes the imperative nature of proper grounding for safety and warranty compliance.
Step-by-step instructions for installing quartz sleeves, including handling and sealing.
Detailed procedure for installing UV lamps, including connections and safety precautions.
Guides on troubleshooting issues with the LED display and checking ballast output voltage.
Provides guidelines for UV lamp replacement based on hours of use and cycle limits.
Covers cleaning procedures for quartz sleeves and recommendations for annual replacement.
Step-by-step procedure for replacing a faulty ballast, including power isolation.
General| Brand | Aquafine |
|---|---|
| Model | SL-1 |
| Category | Steriliser |
| Language | English |
