What to do if LED bulb does not light after replacing a UV lamp in Aquafine SL-10A Steriliser?
If the LED bulb doesn't light after you've replaced the UV lamp, there are a few things you can check: * First, verify the electrical output of the ballast connected to the UV lamp. * If the ballast isn't working, replace it. * If the voltage reading is fine but the LED still doesn't light, replace the LED board.
Detailed safety requirements and precautions for operating UV equipment.
Conditions that will invalidate the equipment warranty.
Guidelines for optimal placement and clearances for UV units.
Recommendations for preventing damage from vibration and piping stress.
Critical importance of proper grounding for safety and warranty.
Step-by-step guide for installing quartz sleeves into the unit.
Procedures for safely inserting and connecting UV lamps.
Checks required before applying power to the UV unit.
Troubleshooting steps for LED display issues related to UV lamps.
Guidelines and procedures for replacing UV lamps.
Procedures for cleaning and replacing quartz sleeves.
General| Brand | Aquafine |
|---|---|
| Model | SL-10A |
| Category | Steriliser |
| Language | English |
To Next Page
