1. IMPORTANT SAFETY INSTRUCTIONS
This guide provides installation and operation instructions for this pump. If you have any other questions
about this equipment, please consult your supplier.
1.1 When installing and using this electrical equipment, basic safety precautions should always be
followed, including the following:
• RISK OF ELECTRICAL SHOCK. Connect only to a branch circuit protected by a ground-fault
circuit-interrupter (GFCI). Contact a professionally trained and qualified electrician if you cannot verify that
the circuit is protected by a GFCI.
• TO PREVENT THE RISK OF ELECTRICAL SHOCK, please connect the ground wire on the motor
(green/yellow) to the grounding system.
•This pump is for use with permanently installed in-ground or above-ground swimming pools and may
also be used with hot tubs and spas with a water temperature under 50℃. Due to the fixed installation
method, this pump is not suggested to be used on above-ground pools that can be readily disassembled
for storage.
• The pump is not submersible.
• Never open the inside of the drive motor enclosure.
1.2 All installations must be fitted with earth leakage or residual current protection devices, having a
rated residual operating current not exceeding 30mA.
WARNING:
• Fill the pump with water before starting. Do not run the pump dry. In case of dry run, mechanical seal
will be damaged and the pump will start leaking.
• Before servicing the pump, switch OFF power to the pump by disconnecting the main circuit to the
pump and release all pressure from pump and piping system.
• Never tighten or loosen screws while the pump is operating.
• Ensure that the inlet and outlet of the pump are unblocked with foreign matter.
To Next Page
Loading...
