Page 4
Page 5
NIGHT GLOW LIGHTING ASSEMBLY INSTRUCTIONS (CONT.)
3. To remove light xture from oat with light xture retaining band:
a. Pull any xture toward the open side of the oat.
b. As the xture meets obstruction of the oat, angle the xture slightly as
shown to clear the oat and continue to pull away from the oat center line.
4. After xtures are installed on the oat, connect the AquaLock (ALC) together.
HAND TIGHTEN ONLY!
CAUTION: HAND TIGHTEN ONLY! Do not use tools such
as a pipe wrench or pliers as you may over tighten and
damage the connectors.
Note: When your unit and/or lighting system requires removal, protective
caps have been provided to maintain a clean cable environment. Simply
hand-tighten one half to your light set and the other half to your cable end.
When you remove the protective caps, keep them in a safe place, such as
the control panel.
To Next Page
Loading...