Need help?Do you have a question about the AquaSure AS-HS32FM and is the answer not in the manual?
General| Model Number | AS-HS32FM |
|---|---|
| Category | Water Dispenser |
| Voltage | 220-240V |
| Color | White |
| Type | Hot & Cold |
| Water Temperature Options | Hot and Cold |
| Cooling Capacity | 2L/h |
| Heating Capacity | 5L/h |
Explains the basic chemistry behind water softening using resin beads to remove ions.
Advises users to inspect all components for damage before proceeding with installation.
Specifies the acceptable temperature range for system operation and installation location.
Details the maximum and minimum allowable water pressure for the system.
Advises on resin degradation due to chlorine/chloramines and suggests carbon filtration.
Lists essential environmental and location considerations before installation.
Instructions on how to safely turn off the home's main water supply before installation.
Guides on attaching the bypass valve assembly to the control head unit.
Details the steps for assembling and preparing the brine tank.
Instructions for preparing the main softener tank and control valve.
Covers connecting the water supply, drain, and brine lines to the softener.
Outlines the process of powering up and initiating the system's initial cycles.
Guides on how to set the current time on the control unit.
Explains how to choose between timer, meter immediate, or meter delay regeneration.
Details how to input the system's water softening capacity in gallons.
Covers setting the regeneration schedule and override options.
Instructions for configuring the duration of the backwash cycle.
Guides on setting the duration for the brine draw and fill cycle.
Details how to set the time for the rapid rinse cycle.
Instructions for setting the time allocated for filling the brine tank.
Explains how the display shows system status in different regeneration modes.
Describes the screen backlight behavior and how to reactivate it.
Details how settings are retained during power interruptions.
Provides instructions for resetting the unit to its factory default configuration.
Explains how to manually initiate or stop a regeneration cycle.
Lists causes and corrections for the system not regenerating as scheduled.
Addresses issues with the regeneration cycle occurring at incorrect times.
Explains potential reasons for reduced water softening capacity.
Outlines causes for softened water not meeting quality expectations.
Provides troubleshooting for situations where the unit consumes too much salt.
Identifies causes for decreased water pressure after installation.
Explains why too much water might accumulate in the brine tank.
Discusses issues preventing the softener from drawing brine correctly.
Addresses problems where the control valve cycles without stopping.
Explains causes for water constantly flowing into the drain line.
Details the warranty coverage for specific components and resin.
Outlines the warranty period for the resin and brine tanks.
Covers general terms, limitations, and exclusions of the warranty.
Provides contact information and procedures for warranty claims.
To Next Page
