Aquatec Fortuna - Troubleshooting

34
EN
6.4 Troubleshooting
Important!
The following table shows a number of common malfunctions and their probable
cause. If a malfunction cannot be eliminated by following the instructions in the
table, please contact your authorised dealer.
Problem Possible causes Remedy
No motor noise/lift does not
move
Battery is not properly inserted
Battery is empty
Contacts are contaminated
Contacts are bent
Cable is damaged
Insert battery (see chapter 5.3)
Recharge battery (see
chapter 5.1)
Clean contacts
Readjust contacts
Contact vendor for replace-
ment of the cable
Lift can be moved upwards but
not lowered
Low-voltage protection is trig-
gered
Recharge battery
Lift stops during lifting opera-
tion
Load is excessive The AQUATEC FORTUNA
may only be used by persons
weighing less than 120 kg.
Battery cannot be recharged Fuse is defective
Battery is defective
Contact your dealer to check
the battery
Replace battery
The bathlift is sliding in the
bathtub
Suction cups are worn or dam-
aged
Replace suction cups